close
    My sink won't empty fully, but if I plug it in I can fill it up and pull the plug it empties to about 2 inches of water.

    0  Views: 1022 Answers: 2 Posted: 11 years ago
    Tags: plumbing

    2 Answers

    It has a clog. Get draino or use a plunger or call a plumber. Pulling the plug is causing just enough suction on the clog to get the sink to drain a little bit. 

    nick.farr.796

    I've poured loads of drain cleaners, from the cheapest to the most expensive and they make no difference, I think the U-bend is too long, for some reason it had to be lengthened as no standard issue pipes will fit.
    Colleen

    Moderator
    A month later and it's still clogged? Your only alternative now is to start taking the pipes off to find the clog. You should snake it too but that might be easier if you send it down an open pipe rather than the sink drain. If it's draining but leaving two inches of water, then the clog is deep down in one of the pipes.

    Thanks for your advice, it helped a lot.



    Top contributors in Uncategorized category

     
    ROMOS
    Answers: 18061 / Questions: 154
    Karma: 1101K
     
    Colleen
    Answers: 47269 / Questions: 115
    Karma: 953K
     
    country bumpkin
    Answers: 11322 / Questions: 160
    Karma: 838K
     
    Benthere
    Answers: 2392 / Questions: 30
    Karma: 760K
    > Top contributors chart
    470176
    questions
    722732
    answers
    791921
    users