1 Answer

Here are its instructions:

Direct Code entry:
1 press and hold the "code search" button until the red indicator stays on, then release the "code search" button.
2. press and release the desired mode button (tv, vcr, etc). the red indicator blinks, then stays lit.
3. Enter the 3 digit code from the code tables (on separate sheet, see following web site: http://www.universal-remote.net/philipsm… - but this may not be your remote model) Note: after a valid code, the red indicator flashes.
4. with your device on, press "channel up". if the device responds, no further programming is required. Note: if some buttons do not operate your equipment, try one of the other codes for your brand.

My phillips codes are 130, 226, 330, 536, 631, 734, 760, which may be different for your tv model. But see below:

Programming with "Code Search"
If your product does not respond after you have tried all the codes for your brand, or if your brand is not listed, try searching for your code by following these steps.
1. Manually turn on the device (tv, vcr, etc.) to be controlled.
2. Press and hold the "code search" button until the red indicator stays on, then release the "code search" button.
3 Press and quickly release the desired mode button (TV, vcr, etc. The red indicator blinks off once.
4. Press the "channel up" button repeatedly (up to 300 times) until the device to be controlled changes channel. The red indicator blinks off with each button press. If you accidentally overshoot the code required, press the "channel down" button to backtrack through the library until the device changes channel. Pressing "channel up" changes direction to forward again.
5. Press and release MUTE to install the code.

GOOD LUCK!

12 years ago. Rating: 2
Comment this answer Add new comment